Radio Shack 22-1670 - Manual (Page 16)

16
3. Press CTY . The detector either displays VG-2 on or
flashes VG-2 off .
4. Press AUD to change the VG-2 setting.
5. Press P/V to save your settings. The detector dis-
plays exit and is then ready for operation.
RECEIVING AND IDENTIFYING
RADAR, LASER, AND SAFETY
WARNING SYSTEM SIGNALS
When you turn on your detector, it sounds alert tones in
the following order: laser, Ka, K, X, and Safety Warning
System.
Your detector displays the band and gives different
audible alerts for each signal. In addition, the alert tone
pulse rate increases and the detector displays more
segments in its signal strength meter as the signal gets
stronger.
When your detector senses instant-on radar, it sounds
an intense, 3-second X, K, or Ka burst and flashes the
received band and a full signal strength meter.
When your detector senses a VG-2 radar-detector
detector, it sounds a 3-second warning and displays
VG2alert RADAR MAY BE IN USE for the duration
of the alert.
22-1670.fm Page 16 Friday, August 6, 1999 10:17 AM