Radio Shack TAD-779 - Manual (Page 9)

9
RECORDING THE
OUTGOING MESSAGE
Before the TAD can answer calls and
record messages, you must record an
outgoing message. Your outgoing mes-
sage can be up to 60 seconds long.
Hint: Do not tell callers you are not
home. Instead, say that you cannot
come to the phone right now.
Follow these steps to record your outgo-
ing message or to change your current
message.
1. Hold down OGM (outgoing mes-
sage) until the TAD beeps.
Note: If you try to record an outgo-
ing message when the TAD’s mem-
ory is full, the PLAY/SKIP indicator
flashes rapidly and the TAD
announces, “Memory is full.” You
must delete some messages to
make room in memory (see “Delet-
ing Messages” on Page 11).
2. Speak your message from about 8
inches in front of the TAD.
3. When you finish, press STOP . The
TAD beeps and plays back the out-
going message.
To check your outgoing message at any
time, press
OGM . If no outgoing mes-
sage is recorded, the TAD-779 says,
“No announcement.”
SETTING THE NUMBER
OF RINGS
Set the ring select switch to 4 , 7 ,or TS to
set how long the TAD waits before it an-
swers a call (4 rings, 7 rings or toll-
saver).
If you plan to check your messages by
long distance, set the ring select switch
to
TS (see “Using the Toll-Saver” on
Page 13).
Illus. showing
microphone.
Illus. showing
4/7/TS switch.
43-779.fm Page 9 Monday, August 16, 1999 7:34 AM