Rangemaster 90 - Manual (Page 29)

29
Electrical Connection
This appliance must be installed by a qual i fi ed
electrician to comply with the relevant In sti tute of
Electrical Engineers (I.E.E.) regulations and also the
local elec tric i ty supply company re quire ments.
WARNING: THIS APPLIANCE MUST BE EARTHED
Note
The cooker must be connected to the cor rect electrical
supply as stated on the voltage la bel on the cooker,
through a suitable cooker control unit incorporating
a double pole switch having a contact separation of
at least 3mm in all poles. This cooker must not be
connected to an ordinary domestic power point.
The cable size used should be between 6mm 2 and
10mm 2 , twin and earth.
Access to the mains terminal is gained by re mov ing
the electrical terminal cover box on the back panel.
Connect the mains cable to the correct terminals for
your electrical sup ply type (see fi g.). Check that the links
are correctly fi tted and that the terminal screws are tight.
Secure the mains cable us ing the cable clamp.
These appliances are of type X with regard to protection
against over heating of the sur round ing surfaces.
Current Operated Earth Leakage Breakers
Where the installation is protected by a 30 milliamp
sensitivity residual current device (RCD), the combined
use of your cooker and other domestic appliances may
oc ca sion al ly cause nuisance tripping. In these instances
the cooker circuit may need to be protected by fi tting
100mA device. This work should be carried out by a
qualifi ed electrician.
Oven Light
Press the oven light switch and check that the light is
working.
NB. The oven light bulb is not included in the guarantee
Hotplate
Check each burner in turn. Push in tap and turn to the
large fl ame symbol. Press ignition switch on facia panel.
Grill
Open the grill compartment door. Turn on the grill control
and check that the grill heats up.
Oven check
Set the clock to the time of day
When the clock is fi rst connected the display will fl ash (
) and ( ) alternately.
To set the clock to read the time of day turn and hold the
Timer knob to the clock symbol
and at the same time
turn the Adjusting knob left or right until the clock shows
the time of day. Remember this is a 24 hour clock.
Let go of the Timer knob and it will spring back to the
vertical oven manual setting.
Turn on the oven and check that the oven fan starts
to turn and that the oven starts to heat up. Turn off the
oven.
Fitting the plinth
Loosen the 3 screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw.
Twist and fi t each end keyhole over their respective
screws. Tighten the fi xing screws.
Customer care
Please complete your details in this Guide, inform the
user how to operate the cooker and hand over the
Instructions.
Thank you.