Rangemaster 90 - Manual (Page 34)

SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check ap pli ance is safe when you have finished.
34
14. To Remove Main Oven Door
Open oven door and remove Handyrack (where fi tted)
by springing one side out of the bracket on the door and
sliding the other side free. Support the door and remove
the two screws securing the upper hinge and packing to
the cooker front. Remove the door from the lower hinge
by lifting slightly and moving outwards.
Reassemble in reverse order.
15. To Change Main Oven Door Outer Panel
Remove the two plastic blanking plugs from the door
handles. Remove the 4mm Hex headed screws holding
the handle to the door with the hexagon key tool.
Remove two screws from top edge and two from bottom
edge of the door.
Remove outer door panel. Fit door handle to new panel.
Fit the plastic blanking plugs to the fi xing holes.
The handles should be above the fi xings.
Fit panel to door. If replacing the outer panel on the right
hand door (with the Thermodial) take care to make sure
the sensor of the Thermodial is sealed to the door by
the rubber grommet.
Reassemble in reverse order.
16. To Change Main Oven Door Catch
Remove outer door panel (see 15). Remove screws
‘B’ holding catch assembly to inner door panel. Fit new
catch and reassemble in reverse order.
Check correct door operation.
17. To Change Oven Door Seal
Open oven door. The seal is held in place by small
hooks on the rear face. At the corner pull seal diagonally
away from the door centre until that hook is released.
Proceed to the next hook and release it in a similar way,
and so on.
Fig. 4
When fi tting new seal, position the seal join at the
bottom. Hook the new seal in one of the corner holes of
the door, and proceed round the door snapping in each
hook in turn.
18. To Adjust Oven Door Catch Keep
Open oven door, slacken off locknut at base of keep,
and screw in or out as required until required fi t is
obtained. Retighten locking nut.
19. To Change Ignition Generator
Disconnect from electricity supply.
Pull cooker forward to gain access to the cover box at
the rear of the left hand cooker. Remove the screws
securing the cover and lift clear. Pull off all the leads
to the generator noting their positions. Slacken the
two screws holding generator to cooker and remove
generator.
Fit new generator to cooker and replace leads.
Reassemble in reverse order. Refer to wiring diagram.
Check ignition performance.