Radio Shack TAD-1024 - Manual (Page 19)

19
TROUBLESHOOTING
If you experience problems with your TAD, try the suggestions in this section. If
you still have problems, contact your local RadioShack store for assistance.
RESETTING THE TAD
If your TAD stops working properly, use a
straightened paper clip to press
RESET on
the left side of the TAD to reset the answer-
ing machine.
Note: The outgoing message and all information stored in memory are erased
when you press
RESET .
Problem Remedy
The incoming message is incomplete. Be sure the memory is not full.
The incoming message is unclear. Be sure VOLUME is set to the desired sound
level.
The TAD does not answer after two,
four, or seven rings. Be sure the TAD is set to answer calls.
Lo flashes on the display. The backup battery is weak. Replace the bat-
tery (see “Installing the Backup Battery” on
Page 7).
The TAD does not respond to the
remote operation security code. Make sure the phone you used to dial the TAD
is a touch-tone phone.
Re-enter your remote operation security code,
pressing each button for 2 seconds.
The remote operation security code might have
reset to the default code due to a power failure.
Make sure the remote operation security code
you entered is correct.
43-784.fm Page 19 Monday, August 16, 1999 7:47 AM