Roberts Radio SRCD970 - Manual (Page 4)

Aerials
The telescopic aerial (5) located on the rear of the SRCD970 is for FM
reception. The telescopic aerial should be fully extended and angled for
optimum reception
There is a built in ferrite aerial for MW stations. Rotate the SRCD970 to the
position giving best reception.
Radio operation (FM)
Slide the Tape/Radio/CD switch (3) to the "Radio" position. Slide the
waveband switch (14) to the “FM Stereo position”. Adjust the volume
control (4) until a hissing sound is heard. Rotate the tuning control (16) until
the desired station is received. If the station being received is in 'Stereo' the
stereo indicator (13) will illuminate. Adjust the volume control (4) and tone
control (1) to the required settings.
If the FM signal becomes weak or is accompanied by a high level of
background hiss, you may select 'MONO' mode by setting the waveband
switch (14) to the "FM" position. To switch off the radio, slide the Tape/
Radio/CD switch (3) to the "Off/Tape" position.
Radio operation (MW)
Slide the Tape/Radio/CD switch (3) to the "Radio" position". Slide the
waveband switch (13) to the “MW” position. Adjust the volume control (4)
until a hissing sound is heard. Rotate the tuning control (16) until the desired
station is received. Adjust the volume control (4) and tone control (1) to the
required settings. Rotate the SRCD970 to the position giving best reception.
To switch off the radio, slide the Tape/Radio/CD switch (3) to the "Off/Tape"
position.