RedMax EXTREME EXZ2460S-PH - Manual (Page 10)

US-10
EXZ2460S-PH
6. Set up
■ MOUNTING ENGINE (SE1)
1. Push the driveshaft housing toward the
clutch housing and rotate it by hand to
check that the driveshaft is engaged
with the gears.
2. Insert the driveshaft housing into the
clutch housing until it bottoms, and
align the positioning holes on the clutch
housing and the shaft tube and install
the screw. When difficult to engage,
twist the engine slightly.
3. Fasten the clamp securely with two
screws.
Tighten the screws gradually by turns.
■ CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to
the joint on the top of the carburetor.
(SE2)
■ CONNECTING SWITCH WIRES
• Connect the switch wires between the
engine and the main unit. Pair the wires
of the same color.
■ INSTALLING HANDLE
(BC-EX3, LRT-EX3 only) (SE3)
• Install the handle to the shaft tube and
clamp it at a location that is comfortable
to you.
(1) About 19 inches (48 cm)
(RMS-EX only) (SE4)
1. Remove both screws from the handle.
2. While spreading the handle at the
mounting hole, position the handle on
the outer tube as shown.
3. Reinstall the two mounting screws in
the handle, but do not tighten them at
this time.
One side of the handle is recessed to
receive the hex nuts.
4. Locate the handle at the best position
for operator comfort (usually about
NOTE
IMPORTANT
SE1
SE2
(1)
SE3
SE4
(1)
SE5
BC-EX3 SE1
LRT-EX3 SE1
BC-EX3 SE2
BC-EX3 SE3
(BC-EX3 only)
■ INSTALLING DEBRIS GUARD
• Attach the debris guard with the bolts
provided to the shaft. (SE1)
■ INSTALLING LINE HEAD (SE2)
1. While locking the gear shaft, by
inserting the supplied tool into the
upper holder on the gear box, loosen
and remove the hexagon nut(left-
handed)
2. Fit the line head assembly to the gear
shaft over the holders. Hand-tighten it
securely.
■ BALANCE UNIT
1. Put on strap and attach unit to strap.
2. Slide clamp up or down until unit
balances with head just touching on the
ground. (SE3)
(LRT-EX3 only)
■ ATTACHING THE TRIMMING
MECHANISM (SE1)
1. Remove the screw screwed into the
end of the trimming mechanism.
2. Insert the end of the trimming
mechanism into the shaft tube.
3. Line up the hole on the end of the
trimming mechanism into which the
screw is to be inserted with the hole on
the shaft tube, and screw the screw
firmly in.
4. Using a wrench, screw in the bolt
10inches (25cm) ahead of the throttle
lever), and secure it by tightening the
knob at the handle base.
■ JOINT ATTACHMENT (SE5)
• Insert the attachment to the main shaft.
• Tighten the knob bolt securely.
(1) Knob bolt