Roland FC-200 - Manual (Page 27)

27
Octave Shift Upper Limit Setting: C0 to C6 to C8
[ ] (High)
In the Note mode, a foot pedal connected to FOOT SW/EXP jack 5 can be used to raise the note
range an octave at a time. This parameter sets the upper limit for raising the note range with the
Octave Shift-Up function.
The setting specifies the key number when “do” (Number pedal 1) is depressed.
* The upper limit cannot be set to a value less than the setting made for the Octave Shift Lower
Limit.
* “C6” refers to a C note (“do”) two octaves higher than middle C (“C4”) on a piano keyboard.
C1 C2 C3 C4 C5 C6 C7 C8
Octave Shift Lower Limit Setting: C0 to C2 to C8
[ ] (Low)
In the Note mode, a foot pedal connected to FOOT SW/EXP jack 6 can be used to lower the note
range an octave at a time. This parameter sets the lower limit for lowering the note range with the
Octave Shift-Down function.
The setting specifies the key number when “do” (Number pedal 1) is depressed.
* The lower limit cannot be set to a value higher than the setting made for the Octave Shift Upper
Limit.
* “C2” refers to a C note (“do”) two octaves lower than middle C (“C4”) on a piano keyboard.
C1 C2 C3 C4 C5 C6 C7 C8
Note On Velocity Setting: 1 to 96 to 127
[ ] (Note On)
This setting determines the volume of the sound produced when a pedal is depressed in the Note
mode. When the velocity is set to a value of 100 or higher, the point indicator at the top left of the
display lights up, and only the last two digits of the value appear on the display.
* If you need information on how to make settings for parameters, see “How to Make Changes” (p. 19).