Radio Shack 15-1186 - Manual (Page 2)

12A98 Printed in Taiwan
5. Use a Phillips screwdriver to loosen the two screws
on the back of the wall plate. Connect the antenna
cable/wires from inside the wall to the rear connec-
tors on the plate, then retighten the screws.
Warning: Be sure the exposed portions of the
cables/wires do not touch each other.
6. Use the two supplied short screws to secure the
plate to the center holes of the brackets.
7. Use a flat-bladed screwdriver to loosen the screws
at the back of the supplied three-prong cable plug.
Connect the 300-ohm antenna wire from the audio
and video outputs of the TV (or the left and right
channels of the FM radio) to the plug, then retighten
the screws.
8. Insert the plug into the wall plate’s jack.
size to fit text
margins
illus of hole on wall w
brackets in place
15-1186.fm Page 2 Thursday, July 15, 1999 1:47 PM