Radio Shack TFX-1032 - Manual (Page 10)

10
• Avoid applying tape to image
areas on copies. The chemicals in
some transparent tape adhesives
could fade the image.
• Avoid storing two copies with the
images together. The printed
image can transfer from one copy
to the other.
• Do not touch the thermal paper
with sweaty or dirty hands.
SETTING THE DIALING
MODE
The TFX-1032 is factory-set to the
tone dialing mode. If your telephone
line uses pulse dialing, you must
change the dialing mode setting. If you
are not sure which type of service you
have, do this test.
1. Lift the handset and listen for a
dial tone.
2. Press any number other than 0.
Note: If your phone system
requires that you dial an access
code (9, for example) before you
dial an outside number, do not
press 0 or the access code.
If the dial tone stops, you have tone
service.
If the dial tone continues, you have
pulse service. Follow these steps to
set your fax to the pulse dialing mode.
1. Press MENU four times. The fax
machine displays:
2. Press SET , then press MENU twice
so the fax machine displays:
3. Press SET twice so the fax
machine displays:
4. Press 0 1 to select the pulse mode.
The fax machine displays:
5. Press SET to save your selection.
The fax machine displays:
6. Press STOP/CLEAR twice. The fax
machine displays the date and
time (or
CHECK PAPER ROLL if
you have not installed paper).
4:SET MODE ?
3:FEATURE SW. ?
TONE (00)
10PPS (01)
(01)PAUSE TIME
43-1204.fm Page 10 Wednesday, August 18, 1999 8:45 AM