Rinnai america ff models – Rinnai Water Heater REU-V2520FFUD User Manual
Page 2
V2532FFU
V2532FFUD
15,000
180,000
120°F
140°F
120°F
140°F
140°F
185°F
140°F
185°F
98°F
120°F
49 Lbs.
87%
49 dB (A)
Normal
75 watts
Standby
5.5 watts
Anti-frost Protection
100 watts
Electronic
Fixed
None
Natural Gas
6" W.C.
Propane
10" W.C.
Natural Gas
10.5" W.C.
Propane
13.5" W.C.
Ignition System
Water Temperature Control
Water Supply Pressure
Electric Connections
Minimum Water Pressure: 20 PSI (Recommended 30-80 PSI for maximum performance)
Safety Devices
Maximum Water Supply Pressure
Remote Control Cable
Flame Failure - Flame Rod
Boiling Protection - 210°F
Over Current - Glass Fuse (3 amp)
Remaining Flame (OHS) 207°F Bi-Metal Switch
Thermal Fuse 264°F
Direct Electronic Ignition
Appliance: AC 120 Volts, 60Hz. Remote Control: DC 12 Volts (Digital)
Simulation Feedforward and Feedback.
Gas Supply: 3/4" MNPT, Cold Water Inlet: 3/4" MNPT, Hot Water Outlet: 3/4" MNPT
Model
Minimum Gas Consumption Btu/h
Maximum Gas Consumption Btu/h
With or without remote controls, mounted in kitchen, bathroom, ect.
Connections
By-Pass Control
Minimum
Gas Supply
Pressure
Maximum
Gas Supply
Pressure
Type of Appliance
Operation
Exhaust System
Approved Gas Type
Electrical
Consumption
Hot water capacity, (50°F rise)
Hot water capacity, (35°F rise)
Default Temperature Setting (no controller)
Maximum Temperature Setting
Minimum Temperature Setting
Weight
Noise level
Efficiency Rating
Automatic Frost Protection - Bi-Metal Sensor & Anti-Frost Heaters
Combustion Fan RPM Check - Integrated Circuit
150 PSI
Non-Polarized Two Core Cable
0.6 to 5.3 GPM
0.6 to 5.3 GPM
Direct Vent - Forced Combustion
Natural Gas or Propane - Ensure unit matches gas type it's being installed on.
0.6 to 6.5 GPM
0.6 to 8.5 GPM
Temperature controlled continuous flow gas hot water system.
104°F
140°F
104°F
140°F
Controller Default Temperature Setting
V2532FFUC
V2532FFUCD
V2520FFU
V2520FFUD
V2520FFUC
V2520FFUCD
Rinnai America
FF Models
S P E C I F I C A T I O N S
NOTE: Rinnai is continually updating and improving products, therefore, specifications are
subject to change without prior notice. Local, state, provincial and federal codes must be adhered
to prior to installation.