Ryobi SS180 - Manual (Page 11)

11
INSTALLING BATTERY PACK
See Figure 7.
Follow these directions when installing the battery pack.
■ Place battery pack on the Speed Saw.
■ Align raised rib on battery pack with groove in saw's
battery port.
■ Make sure the latches on each side of the battery
pack snap in place and that battery pack is secured
on the tool before beginning operation.
REMOVING BATTERY PACK
See Figure 7.
Follow these directins when removing the battery pack.
■ Locate latches on side of battery pack and depress
both sides to release battery pack from the Speed
Saw.
■ Remove battery pack from the Speed Saw.
CAUTION:
When placing battery pack on your Speed Saw, be
sure raised rib on battery pack aligns with groove in
saw’s battery port and latches snap in place properly.
Improper assembly of battery pack can cause
damage to internal components.
STARTING/STOPPING SPEED SAW
See Figure 8.
Follow these directions when starting and stopping the
Speed Saw.
To start Speed Saw: Depress the switch to the I position.
To stop Speed Saw: Depress the switch to the O position.
CAUTION:
We suggest that you practice with your Speed Saw
before installing a bit and making cuts.
OPERATING SPEED SAW
See Figure 9.
Follow these directions when operating the Speed Saw.
■ Hold Speed Saw firmly with both hands.
■ Start Speed Saw.
■ Tilt Speed Saw at a 45
o angle.
■ Plunge bit into material using guide ring as a pivot.
■ Raise Speed Saw slowly to a 90
o angle.
■ Begin cutting.
Fig. 9
Fig. 8
OPERATION
Fig. 7
BATTERY PACK
LATCHES
LATCHES
DEPRESS
DEPRESS
TO START SPEED
SAW
TO STOP SPEED
SAW