Radio Shack 120-2182 - Manual (Page 13)

4. Slide the CD changer's door all the way to the left to close it.
To unload the CD magazine from the CD changer, slide the CD changer's door
open, then press EJECT to eject the magazine.
Note: The CD changer must be connected to power to eject the magazine.
Playing CDs
CAUTIONS: The CD changer has a wide dynamic range. If you turn up your
radio's volume too high during soft (low volume) sections of a
program, your speakers might be damaged when a sudden loud
passage occurs.
If the CD changer is jolted during play, the rotation speed
might suddenly change or the CD changer might make an unusual
noise. This is not a malfunction.
Notes: To play CDs, you must load them into the CD magazine, then load
the magazine into the CD changer. The display continues to flash
if you did not load CDs into the magazine, or did not load the
magazine into the changer. The changer displays the number for
each CD loaded in the magazine (1-10). Then the changer selects
the CD you loaded into the lowest slot number.
If you connected the Audio Adapter's antenna plug to your sound
system's antenna jack, you must select the FM band on your sound
system's radio and tune to the same frequency as the 89.1/88.7 MHz
setting on the Audio Adapter. For easy operation, store this
setting as one of your sound system's preset stations.
To turn on the CD changer and play a CD, press >|| (Play/Pause) on either
the infrared remote control or the CD changer controller. The CD starts to
play from Track 1 of the CD in the lowest numbered slot. The display shows
DISC and the track number.
Note: The CD changer controller has only >|| and OFF buttons. To control
other functions, use the infrared remote control.
After the CD changer plays each track on the CD, it automatically selects
the next loaded CD (from lowest to highest) and plays all tracks on that
CD, starting with Track 1.
When the CD changer has played all tracks on all loaded CDs, it
automatically plays the lowest loaded CD, starting with track 1. Play