Rosewill RNX-N400LX - Manual (Page 26)

Wireless Router RNX-N400LX User Manual
3.35 Wireless – WDS Settings
Wireless Distribution System uses wireless media to communicate with other APs, like
the Ethernet does. To do this, you must set these APs in the same channel and set MAC
address of other AP that you want to communicate with in the table and then enable the
WDS.
Item Description
Enable WDS Click the check box to enable wireless distribution system.
MAC Address
Fill in the MAC address of AP to register the wireless distribution
system access capability.
Data Rate
Select the transmission data rate from pull-down menu. Data rate
can be auto-select, 1M to 54Mbps or MCS.
Comment Fill in the comment tag for the registered client.
Apply Changes
Click the Apply Changes button to complete the new configuration
setting.
Reset
Click the Reset button to abort change and recover the previous
configuration setting.
Set Security
Click button to configure wireless security like WEP(64bits),
WEP(128bits), WPA(TKIP), WPA2(AES) or None
Show Statistics It shows the TX, RX packets, rate statistics.
Delete Selected
Click to delete the selected clients that will be access right removed
from this WLAN Broadband Router.
Delete All Click to delete all the registered clients from the access allowed list.
Reset
Click the Reset button to abort change and recover the previous
configuration setting.
3.351 WDS Security Setup
Requirement: Set [Wireless]->[Basic Settings]->[Mode]->AP+WDS
This page is used to configure the wireless security between APs.
26