Renesas FLASH Development Toolkit 3.07 - Manual (Page 140)

126
Selecting to set the locks will cause FDT to lock and unlock the blocks as appropriate and also set the
master lock enable - as in (1) above. Selecting to do nothing will cause FDT to ignore any locking settings
and skip straight to the disconnection process - as in (3) below. Clicking 'Cancel' at this point will cancel
both the dialog and the disconnect operation as a whole.
3. Do Nothing
FDT will issue no lock or unlock commands and the device will be left in its current locking state. The
disconnection process will happen as normal.