Radio Shack Light and Learn Remote - Manual (Page 11)

11 Preparation
4. Enter the two-, three- or four-digit number for your
favorite channel.
5. If you entered a two- or three-digit channel num-
ber, you must do one of the following: if your orig-
inal remote requires you to press Enter or Select
to send a command, then do so after entering the
digits of your favorite channel. If your original
remote does not require you to press Enter or
Select to send a command, then after entering
your two- or three-digit channel number, press
P .
If you entered a four-digit channel number, do not
press
P .
6. Repeat Steps 4–5 up to nine more times to store
another favorite channel for the same device, or
exit the program by pressing
P until the red light
blinks twice.
7. To exit the program, press P until the red light
blinks twice.
Once you have programmed all 10 favorite channels,
the remote automatically exits favorite channel setup.
Resetting Scan
Once you have programmed SCAN/FAV for Favorite
Channel Scan, you cannot use it for Channel Scan un-
less you reset it.
To reset SCAN/FAV , follow these steps.
1. Select either TV or CBL/SAT .
2. Hold down P until the red light blinks twice.
3. Press 9 9 6 . The red light blinks twice. You can
now use the remote for Channel Scan (see
“Using Channel Scan” on Page 16).
4. Hold down P until the red light blinks twice.