Radio Shack Light and Learn Remote - Manual (Page 12)

12 Preparation
PROGRAMMING MACROS
Your remote has four macro keys ( MUSIC , MOVIES ,
SPORTS , and NEWS ) that store up to three channels
per macro key for instant tuning of TV or cable/satellite
channels. For example, if your favorite sports channel
on your cable service is 061, you can store it as an in-
stant tune-in macro.
Follow these steps to program macros.
1. Hold down P until the red light blinks twice.
2. Press 9 9 5 . The red light blinks twice.
3. Press the desired macro key ( MUSIC , MOVIES ,
SPORTS , or NEWS ).
4. Press CBL/SAT or TV to select a device.
5. Press the numbers for the desired channel ( 0 6 1
for the sports channel in the previous example).
6. Hold down P until the red light blinks twice.
Note: If your original remote control requires you
to press Enter or Select to send a command,
press Enter or Select after entering your channel
number. Then, hold down
P until the red light
blinks twice.
If you want to add two more channels to the macro
keys, repeat Steps 1–6 twice, each time substituting
another channel number in step 5.
Note: You can only program three channels for each
macro key. Programming more than three channels
will overwrite one or more of your original channel set-
tings.
PROGRAMMING THE POWER KEY
Your remote can store a power on/off sequence to
control the power of up to six devices with a single key
press. Once the desired sequence is stored,
POWER
acts as a master power key when held down for at
least 2 seconds.