RAD Data comm ASM-60 - Manual (Page 67)

ASM-60 Installation and Operation Manual Appendix C IR-IP Interface Module
View Menu C-23
Reset WAN
➤ To reset the WAN interface:
• From the Resets menu, type 3.
You will be prompted to confirm the reset operation.
Resetting the WAN interface causes the WAN controller to be restarted. This results
in renegotiation of the WAN protocol parameters.
To continue your Telnet session, press any key within 15 seconds following the
confirmation of the reset operation.
C.11 View Menu
The View menu is used to view the IR-IP configuration data, and display
information on its ARP tables, multicast Groups tables and statistics.
➤ To access the View menu:
• From the Main menu, type 5.
The View menu appears (Figure C-19).
IR_IP <IR-IP> S/W Ver. 1.00 31/IR (date)
Quick Setup
Management Access
Advanced Setup
Device Control
View
----------------------------------------------------------
1. Configuration and Connection
2. ARP Tables
3. Multicast Groups Table
4. Statistics
Press one of the numbers to select or ESC:
Figure C-19. View Menu
Configuration and Connection
This screen is used to view the configuration parameters of IR-IP. In addition, you
can also view the current status of the LAN and WAN interface.
➤ To access the Configuration and Connection screen:
• From the View menu, type 1.
The View Configuration screen appears (Figure C-20).
Note