Radio Shack 21-1864 - Manual (Page 2)

2
Complete charging takes about 10 hours. ±
When charging is complete, unplug the AC
or DC adapter from the power source, then
disconnect it from the radio’s
DC 6V jack. #
7 5+0) "6 *' "5 9+8'. "$ '.6 "% .+2
Insert the swivel belt clip into the socket at
the back of the radio until it clicks. To
remove the clip, press the button at the top
of the belt clip and pull out the clip.
7 5+0) "# 0 "1 26+10#. "9 4+56 "5 64#2
You can attach an optional wrist strap (not
supplied) to the radio. Slide the wrist strap’s
small loop under the bar at the top of the
radio. You might need to use a small
screwdriver or a straightened paper clip to
do this. Then pull the strap’s large loop
through the small loop.
12'4#6+10
% 10641.5
PTT – Hold down and speak into the
microphone to transmit. TX appears.
Release to stop transmission.
±
MON – Hold down to hear everything on a
channel, even weak transmissions. Release
to turn auto-squelch back on.
VOL/OFF – Rotate to turn the radio on and
off and adjust the volume.
¼ý / SCAN – Press to manually select a
channel. The selected channel number
appears. Hold down for about two seconds
to scan through the channels. The radio
automatically scans through the channels
and pauses on each active channel. To
restart scanning when the radio pauses on
an active channel, press
¼ý / SCAN again . To
stop scanning, press PTT . ±
¹ý / CALL – Press to manually select a
channel. The selected channel number
appears. Hold down to send a page to other
FRS radios set to the same channel.
JN JN JN JN
appears and the call tone sounds. After you
hold down
¹ý / CALL for about six seconds,
the tone stops.
(45"( 4'37'0%+'5
7 5+0) "- '; ". 1%-
To lock or unlock ¼ý / SCAN , ¹ý / CALL and
QUIET/MENU , hold down MON then press
PTT . É appears when the keys are
locked. ±
3 7+'6 "% 1&'5
Quiet Codes lets you talk and listen to other
radios set to the same channel and quiet
code. This is like having a sub-channel
within a channel, giving you greater
communication flexibility. When you set a
quiet code and turn on this feature, you can
communicate with anyone who has a radio
set to the same channel and code.
1. Press QUIET/MENU until the quiet code
number flashes.
2. Repeatedly press ¼ý / SCAN or ¹ý / CALL
until you see the code number you want
to use. (See the “Quiet Code Chart” for
complete list of quiet codes).
3. Press PTT to store the code.
4. To turn off the quiet code feature, press
QUIET/MENU once. The quiet code
number disappears.
3 7+'6 "% 1&' "% *#46
±
"016'"
±
"
Recharging Ni-Cd or Ni-MH Batteries
• Average charge time varies, depending on
capacity. Typically, Ni-MH batteries charge
in about 10 hours. Ni-Cd batteries charge in
approximately four hours.
• You can use your radio while charging the
batteries if you employ a DC to DC
regulated and filtered adapter (such as
RadioShack catalog number 273-1859), but
not if you employ an AC to DC regulated
adapter (such as 273-1762).
Controls
• If you hold down PTT over 2 minutes, the
radio automatically stops transmitting to
save power. The radio will generate an alert
tone and
JN JN JN JN
will flash on the display if you
continue to hold down PTT.
• The radio automatically scans through quiet
codes while scanning through the channels.
The quiet code feature automatically turns
on when a signal is detected on a channel
and quiet code, and turns off after the signal
disappears. To stay on the active channel
and quiet code, press PTT to stop scanning
before the signal disappears.
Using Key Lock
When the keys are locked, you can still send a
page to other FRS radios set to the same
channel by holding down
¹ý
/CALL, but you
cannot select a channel by pressing
¹ý
/CALL.
# "+/2146#06" #
The EPA certified RBRC®
Battery Recycling Seal on the
nickel-cadmium (Ni-Cd) battery
indicates RadioShack is
voluntarily participating in an
industry program to collect and recycle these
batteries at the end of their useful life, when
taken out of service in the United States or
Canada. The RBRC program provides a
convenient alternative to placing used Ni-Cd
batteries into the trash or the municipal waste
stream, which may be illegal in your area.
Please call 1-800-THE-SHACK (1-800-843-
7422) for information on Ni-Cd battery recycling
and disposal bans/restrictions in your area.
RadioShack’s involvement in this program is
part of the company’s commitment to
preserving our environment and conserving our
natural resources.
%JCPPGN"% (TGSWGPE["*/*\+
1 462.5625
2 462.5875
3 462.6125
4 462.6375
5 462.6625
6 462.6875
7 462.7125
8 467.5625
9 467.5875
10 467.6125
11 467.6375
12 467.6625
13 467.6875
14 467.7125
%QFG (TGSWGPE["**\+
1 67.0
2 71.9
3 74.4
4 77.0
5 79.7
6 82.5
7 85.4
8 88.5
9 91.5
10 94.8
11 97.4
12 100.0
13 103.5
14 107.2
15 110.9
16 114.8
17 118.8
18 123.0
19 127.3
20 131.8
21 136.5
22 141.3
23 146.2
24 151.4
25 156.7