Renesas Single-Chip Microcomputer M306NKT3 - Manual (Page 126)

110
10.1.2 AutoDisconnect
This forces FDT to automatically disconnect after programming, so that the user does not need to press
the Disconnect button.
10.1.3 Readback Verify
This option controls whether FDT automatically performs a read and compare operation after
programming. The setting is remembered between sessions.
10.1.4 Request Checksum
This option controls whether FDT automatically performs a checksum request operation after
programming. The setting is remembered between sessions.
10.1.5 Erase Device Before Program
This option controls whether FDT automatically performs an erase operation before programming the
device. This will erase all blocks in all memory areas prior to programming. The setting is remembered
between sessions.
10.1.6 Security Protection
This option controls whether FDT should security protect QzROM devices as it disconnects. Select
“Automatic” to always protect the device at disconnection. Select “Prompt” to query the user what to
do and select “None” to never protect the device at disconnect. NB – a protected device cannot be
reconnected to.
10.1.7 New Settings…
Run the Wizard to allow entry of the new settings.
10.1.8 About…
Shows the About box.
10.2 Dialog Controls
10.2.1 Exit
Clicking this will exit FDT and FDT will start up in the Simple Interface Mode next time it is loaded.
This will be disabled if the user currently logged in to FDT does not have the ‘SimpleInterface:Exit’
access. [see Chapter 5 for details]
10.2.2 Download File radio button
This will be disabled if the user currently logged in to FDT does not have the
‘SimpleInterface:Download File’ access. [see Chapter 5 for details]