Renesas Single-Chip Microcomputer M306NKT3 - Manual (Page 92)

76
7.6.5 Close All
This option closes any files open in the editor window.
7.6.6 ‘file name’
This option becomes active when a file name is selected and checked.
7.7 Device Menu
The ‘Device’ menu provides control facilities for interacting with the target device.
7.7.1 Connect to Device
This connects the GUI to the device if it is not connected. Progress messages will appear in the Output
window.
7.7.2 Disconnect
This disconnects the GUI from the device if it is connected. Progress messages will appear in the output
window.
7.7.3 Erase FLASH blocks
This launches the ‘Erase Blocks’ dialog box.
The ‘Erase Blocks’ dialog box allows the user to specify which blocks are to be erased. The Written
column indicates whether data is present in the block.
To start the operation, select the required block names in the list and then click the Erase button.
7.7.4 Blank check
This launches a blank check on the device FLASH and reports back to the Output window.
7.7.5 Upload Image
This launches the ‘Upload Image’ dialog box, which enables the uploading of a range of data from the
target device. This is intended for access with FLASH memory. The data is placed in the Editor
window.
7.7.6 Download Active File
This downloads the current active file into the target FLASH memory.
7.7.7 FLASH Checksum
This launches a checksum calculation on the device FLASH and reports back to the Output window.
This is an EPROM Style checksum which is a 32 bit addition of the byte values within the range of the
flash, padded with 0xFF’s to the next EPROM size (eg 64Kb, 128Kb etc).