Rangemaster 110 - Manual (Page 30)

30
INSTALLATION
Check the ap pli ance is electrically safe and gas sound when you have fi nished.
Moving the Cooker
The cooker is very heavy. Take great care.
We recommend two people manoeuvre the cooker.
Ensure that the fl oor covering is fi rmly fi xed, or removed
to prevent it being disturbed when moving the cooker
around. You will need the levelling tool.
From the back tilt the cooker forward and remove the
rear half of the polystyrene base pack.
Repeat from the front and remove the front half of the
poly base.
Find the 3 adjusting nuts at the base of the front of
the cooker. These lower the rollers from their storage
positions.
The centre adjuster controls the central front roller,
the outer 2 controls the rear rollers
Fit the levelling tool to each adjusting nut in turn and
lower the rollers by making 10 complete (360º) turns
clockwise. (This means turning and removing the
levelling tool 20 times).
Make sure you lower all three rollers.
Unfold the rear edge of pack base tray.
Open the grill door and Slow oven door. With your hands
under the bottom edge of the hot plate facia, lift the
front of the cooker slightly and then roll the cooker on
the rollers.
Unfold the rear edge of pack base tray. Carefully push
the cooker backwards out of the base pack. Push the
cooker close to its fi nal position, leaving just enough
space to get behind it.
Take care not to twist it within the gap between the
kitchen units as damage may occur to the cooker or the
units.
Conversion to LP
If the appliance is to be converted to LP gas do the
conversion at this point. See the conversion section
of these instructions.