RCA IP900 - Manual (Page 17)

Chapter 2: Remote Control
Chapter 2 15 Illustrations contained in this document are for representation only.
Using Automatic Code Search to Program Your TV
You can program the remote to operate your TV. To stop the
automatic code search without programming your TV, press
EXIT•CLEAR until the indicator on the remote turns off.
Note: AUX can’t be programmed using the automatic code search
method.
1. Turn on your TV.
2. Press and hold the TV button. While holding TV, press and hold
ON•OFF until the indicator on the remote turns on, then release
both buttons.
3. Point the remote at the TV. Press and release PLAY, then wait 5
seconds or until the indicator on the remote stops flashing.
At this point the remote is searching for the correct code to
program. If, after 5 seconds, the TV does not turn off, press PLAY
again to search the next set of codes.
Continue pressing PLAY until the TV turns off or you have
searched through all of the codes. There are 20 total sets of codes.
If the TV does not turn off after pressing PLAY 20 times, then the
remote can’t be programmed to operate it.
If the TV does turn off:
1. Press and release REVERSE, then wait 2 seconds. Repeat this step
until it turns back ON.
2. Press and hold STOP until the indicator on the remote turns off.
Use these buttons when
you program the remote.
PLAY REV•REPLAY
STOP
AUX ON • OFF TV
EXIT•CLEAR
Indicator
Important: The remote may not be
compatible with all models of all
brands of components. It may not
operate all functions of the remote
that came with your component.
Note: If you need to replace the
batteries in the remote, don’t
press any buttons. If you do,
you’ll have to reprogram the
remote.
How to Use the Remote After You’ve Programmed It
Because this universal remote can control several different components (TV, DVD, VCR, A/V receiver) it
uses operational modes triggered by the component buttons. For example, if you want the remote to
control the TV, press the TV button to put the remote into TV mode.
1. Press the appropriate component button (TV, AUX, VIDEO, Web, etc.) to set the remote to control the
component.
2. Press ON•OFF to turn the component ON or OFF.
3. Use the remote buttons that apply to that component.
Notes:
• The remote may not be compatible with all brands and models of components. It also may not operate
all functions of the remote that came with your component.
• If you keep pressing buttons and nothing happens, the remote is probably in the wrong mode. You
must press the component button that matches the component you want to operate (i.e., if you want
to operate the TV, press TV on the remote control to put the remote in TV mode.)
IP900.02 Remote 10/24/03, 12:35 PM 15