RCA IP900 - Manual (Page 27)

Chapter 4 25 Illustrations contained in this document are for representation only.
Chapter 4: Additional Information
Front of the Decoder
Power indicator – Indicates whether the unit is on or in standby mode. Flashes when there is a broken
connection to the service provider or service is momentarily unavailable.
power
Back of the Decoder
When connecting, make sure you connect Output jacks to Input jacks, Video to Video, Right Audio to
Right Audio, etc. A description of each jack follows.
Description of Jacks (from left to right)
1. ETHERNET – Connects to your Ethernet cable from your home network or modem.
2. AUDIO OUT (R and L) – Connects your decoder to a TV or A/V receiver for improved sound.
3. RF MOD – Connects to the RF modulator (not included) to power the modulator. This connection is
only necessary if your TV or VCR doesn’t have audio / video input jacks.
4. VIDEO OUT – Connects to the Video Input jack on your TV.
5. S-VIDEO OUT – If your TV has an S-VIDEO jack, connects your TV for better picture quality than
using the VIDEO jack.
6. DIGITAL AUDIO OUT OPTICAL – Connects your decoder to a Dolby Digital receiver or decoder using
a digital optical connection.
7. POWER – Connects to the power supply.
ETHERNET AUDIO
R L
RF
MOD
VIDEO S-VIDEO DIGITAL
AUDIO
POWER
1 2 3 4 5 6 7
IP900.04 Additional 10/24/03, 12:35 PM 25