4 installing the primary projection lens, Installing the primary projection lens, Pre l iminar y – Runco SIGNATURE CINEMA SC-50D User Manual
Page 41
Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual
25
PRE
L
IMINAR
Y
3.4
Installing the Primary
Projection Lens
The projection lens is shipped separately from the projector. Proceed as follows to install
it:
1.
Remove the lens plug from the lens opening in the projector.
2.
Remove the rear cap from the lens. (Keep the front lens cap on the projection lens to
protect it from damage during the installation process.)
3.
Rotate the lens clamp to the OPEN position.
4.
Remove and retain the two security screws from the
lens mount.
5.
Align the lens interface plate with the lens mount. Align the lens electrical connector
with the mating connector on the lens mount. Fully insert the assembly straight into
the lens mount opening without turning. Press using your hand.
6.
While holding the lens flat against the lens mount, rotate the lens clamp clockwise to
lock the lens assembly in place.
7.
Re-attach the lens mount security screws that you removed in Step 4.
8.
Remove the front lens cap.
Never operate this projector without a lens. The lens seals the
projector, preventing contaminants from entering the interior of the
projector.
When installing the lens, ensure that it is not inserted at an angle, as
this can cause damage.
WARNING
CLAMP CLOSED
MOUNTS
CLAMP OPEN
SECURITY
SCREW
SECURITY
SCREW
Security
Screws
Note