Royal Sovereign 1050 - Manual (Page 10)

1. HOT FILM
RSH-1050/1650 RSR-685/1050
1. Insert bar into the core of the roll film then place the bar on the machine.
2. Place the Pressure Lever (on the right side of machine) to the open mode at 15mm.
3. Insert a piece of wide cardboard (guiding paper/carrier) between the rollers.
4. Pull the film from the upper roller passing over the upper idle bar to the upper roller
and put it on the roller.
5. When temperature reaches 80℃（176°F）, resin starts melting and films turn to be
transparent.
6. Place the film from lower shaft beneath the film from the upper roller which is already
melting and unwind films of both rollers 30~40Cm(1~1.3ft) for loosing the tension.
7. Set the pressure Lever to the 1mm.
8. Set speed at 1 and press Run button. The films will be fed into the machine and will
come out from the rear site of machine.
9. Check the status of lamination and place the pressure lever at lamination mode.
2. COLD FILM
UPPER ROLL FILM
UPPER IDLE BAR
HOT ROLLER
LOWER IDLE BAR
LOWER ROLL FILM
HOT METAL ROLLER
LOWER ROLL FILM
LOWER IDLE BAR
UPPER ROLL FILM
UPPER IDLE BAR
ROLLER
TAKE UP DEVICE
COLD FILM
TAKE UP DEVICE
COLD FILM
- 10 -