Royal Sovereign 1050 - Manual (Page 6)

1. Disassemble both the Right cover and the Left cover. (Note :Turn the fastening nut of the Emergency
switch counterclockwise and disaasemble the Emergency switch before disassembling the Right cover.)
2. Disassemble the Rear cover.
3. Disassemble the power switch bracket which is located at the left side of the machine.
4. Put the Plate-Rewinder L on the outer side of the frame as shown in the following figure
and fasten it with six M5 screws.
5. Put the Plate-Rewinder R on the outer side of the frame as shown in the following figure
and fasten it with six M5 screws.
6. Insert the male connector from the Rewinder motor into the female connector from the
How to install the rewinder
M5 screw 6EA
Power switch bracket
Plate-Rewinder L
Plate-Rewinder R
- 6 -