RCA E13344 - Manual (Page 6)

GETTING STARTED
4
TV/VCR Connection
The basic connection (TV and VCR), right,
is the most common connection and
is therefore used to illustrate a single
component connection with your TV.
Cables
You will use either of the following type
of cable to make your connection:
Coaxial Cables: Carries
the signal from the
antenna or cable directly
to the television or
through a cable box, as
needed by your cable
system.
Audio/Video Cables:
Carries audio and video
from a component to
the TV.
How to View the VCR
To watch the VCR with the connection
using the
CABLE/ANTENNA jack, tune
the TV to Channel 3 or 4. To watch
the VCR with the connection using the
AUDIO/VIDEO in jacks, tune the TV to the
Video Input (press 0, 0 on the remote).
VCR 1
TV
AUDIO VIDEO
OUT
IN FROM ANT
OUT TO TV
CH3
CH4
AUDIO VIDEO
CABLE/
ANTENNA
CABLE, CABLE BOX, OR ANTENNA
VCR 1
AUDIO VIDEO
OUT
IN FROM ANT
OUT TO TV
CH3
CH4
TV
CABLE/
ANTENNA
AUDIO VIDEO
CABLE, CABLE BOX, OR ANTENNA
OR
TIP
Your TV is equipped with an audio/video input. To tune to the audio/video input, press
“0, then 0” (zero button twice) on the remote. The audio/video input can also be added
to the channel scan list and accessed by the channel up and down buttons.
Video (yellow)
Right Audio (red)
Left Audio (white)
Video (yellow)
Right Audio (red)
Left Audio (white)