Runco CP-42HD - Manual (Page 26)

12 Runco CP-42HD/CP-52HD Owner ’s Operating Manual
3. Installation
For the first time use of the remote control, please pull out the PET Film.
To change the battery in the remote control:
1. Remove the six screws on the back of the remote.
2. Remove the battery and replace with another Lithium CR2032 Battery.
3. Please follow the drawing to remove the screws and replace the battery.
Make sure that there is nothing obstructing the infrared beam between the
remote control and the IR receiver on the projector.
If the effective rage of the remote control decreases, or it stops working,
replace the battery with a new one.
Ambient conditions may possibly impede the operation of the remote control.
If this happens, point the remote control at the monitor, and repeat the
operation.
This remote control is waterproof and floats.
3.1
Remote Control
Battery Installation
Notes on Remote Control
Operation
Battery Installation
PET Film Removal