Rolls MX902 - Manual (Page 3)

Front Panel
CHANNEL DESCRIPTIONS
HIGH: Boosts or cuts the 12.5 kHz or high frequency portion of the signal.
LOW: Boosts or cuts the 60 Hz or low frequency portion of the signal.
AUX 2: Controls the amount of post-fader signal that is sent to the Aux 2 bus
and output.
AUX 1: Controls the amount of pre-fader signal that is sent to the Aux 1 bus
and output.
PAN: Varies the amount of relative signal sent from Channels’ 1 through 3 to
the Main Level control.
BAL: Varies the amount of stereo signal from channels 5/6 through 8/9 to the
Main Level control.
LEVEL: Controls the overall output signal level of the channel.
MASTER DESCRIPTIONS
AUX 2 RETURN: Controls the amount of input signal from the RCA Aux 2 Return
jacks.
AUX 1 RETURN: Controls the amount of input signal from the Aux 1 Right and Left
Return jacks.
HEADPHONE LEVEL: Controls the amount of level of signal from the Headphone
Output.
HEADPHONE OUTPUT: 1/4” TRS stereo jack for connection to stereo headphones.
NOTE: Do not use a mono 1/4” TS plug in this jack. Doing so may result
in serious damage to the MX902.
MAIN LEVEL: Controls the amount of signal sent to the Right/Left output jacks.
-OO +15
LEVEL
-OO +15
LEVEL
HDPHN
0 10 AUX 2
RETURN
0 10 AUX 1
RETURN
AUX 2 RET
L R CLIP PWR
HDPHN
OUT
MAIN
MX902
L
R
12 - 18 VDC
+
-
POWER
0 10 0 10
-15 +15
AUX 1
0 10 AUX 2
60
LOW
12.5 k
HIGH
L R PAN
-15 +15
LEVEL
-OO +15
-15 +15
AUX 1
0 10 AUX 2
60
LOW
12.5 k
HIGH
L R BAL
-15 +15
LEVEL
-OO +15
3 4/5
2