Rolls MX902 - Manual (Page 4)

Jack Panel Description
+6 +50
MIC 1 MIC 2 MIC 3
LINE 1
-6 dB
LINE 2
-6 dB
LINE 3
-6 dB
5/RIGHT 7/RIGHT 9/RIGHT
4/LEFT/MONO 6/LEFT/MONO 8/LEFT/MONO
AUX 1
SEND
AUX 2
SEND LEFT OUT RIGHT OUT
AUX 1
RET LEFT/MONO
AUX 1
RET RIGHT
PHANTOM
PWR
dB
+6 +50
dB
+6 +50
dB
TRIM TRIM TRIM
Channels 1 through 3
MIC INPUT: XLR input jack for microphone level or balanced signals.
TRIM: Controls the amount of input gain from +6 to +50 dB.
LINE: 1/4” unbalanced input for instrument of line level signals.
PHANTOM POWER SWITCH: Engages the +24 volts of phantom power, used to power con-
denser microphones.
Channels 4/5 through 8/9
LEFT: 1/4” unbalanced input for instrument or line level signals.
RIGHT: 1/4” unbalanced input for instrument or line level signals.
Master
AUX 1 and 2 SEND: 1/4” unbalanced jacks for sending out the signals present on the Aux 1 and 2
buses.
RIGHT OUT: 1/4” TRS balanced main right output.
LEFT OUT: 1/4” TRS balanced main left output.
AUX 1 RET. RIGHT and LEFT: 1/4” unbalanced jacks for receiving stereo signals sent from the
Aux 1 bus (usually through an effects processor).
AUX 2 RET. Stereo RCA jacks for receiving stereo signals send from the Aux 2 bus, or may be
used as an auxiliary stereo source input such as a CD or cassette player.
Side Panel
12 - 18 VDC: For connection to a sleeve positive, DC power adapter.
POWER Switch: Applies power to the MX902 when connected to a proper power source.
3