Raritan Computer Raritan ASMI G4 - Manual (Page 22)

Chapter 4. ASMI G4 Module Configuration
New super-user password
Enter the new password for the super-user.
New password (confirm)
Re-type the new password for the super-user.
Press the "OK" button to accept the changes and close the window. If you wish to abandon the changes,
press the "Cancel" button (on Windows). On a Linux system simply close the window by clicking the
required button of the window frame.
Initial Configuration via DHCP Server
By default, the ASMI module will try to contact a DHCP server in the subnet to which it is physically
connected. If a DHCP server is found, it may provide a valid IP address, gateway address and net mask.
Before you connect the device to your local subnet, be sure to complete the corresponding configuration
of your DHCP server. It is recommended to configure a fixed IP assignment to the MAC address of the
ASMI module. You can find the MAC address on the outside of the shipping box and labelled on the
bottom side.
If this initial configuration does not meet your local requirements, use the setup tool psetupto adjust the
values to your needs. The psetuptool can be found on the CD ROM delivered with this package. You can
then employ the procedure described below.
Web Interface
The ASMI module may be accessed using a standard Java enabled web browser. You may use the HTTP
protocol or a secure encrypted connection via HTTPS to reach the ASMI module. Simply enter the
configured IP address of the ASMI module into your web browser.
The initial login settings are:
Table 4-2. Default User Settings
Parameter Value
Login super
Password pass
Changing these settings to user specific values is strongly recommended and can be done on the "User
Management" page (see
the Section called Users And Groups in Chapter 6 ).
13