Radio Shack TAD 3809 - Manual (Page 11)

11 Preparation
1. Hold down SET until the TAD beeps. The TAD announces,
“Sunday,” and
34 34 34 34
appears.
Note: If necessary, slide VOLUME on the right side of the
TAD to the desired listening level.
2. To change the day of the week, repeatedly press CODE/
REPEAT to move backward or MEMO/SKIP to move forward
until the TAD announces the desired day of the week.
3. Press PLAY/STOP . The TAD beeps once, then displays the
current set hour and announces either “AM” or “PM.”
4. Repeatedly press SKIP/MEMO or CODE/REPEAT until the
TAD displays the desired hour.
Note: The TAD changes the AM/PM setting each time it
reaches
45 45 45 45
.
5. Press PLAY/STOP . The TAD beeps once to confirm the hour
setting.
6. To change the minutes, repeatedly press CODE/REPEAT or
SKIP/MEMO until the desired minute appears.
7. Press PLAY/STOP to confirm the settings. The TAD beeps
and announces the day and time.
Note: To check the current day and time at any time, press SET .
RECORDING AN OUTGOING MESSAGE
Before you can set the TAD to answer calls, you must record
the outgoing message (OGM) the caller hears when the TAD