Ryobi RY43006 - Manual (Page 18)

18
n Felling Backcut. The backcut is always made level and
horizontal, and at a minimum of 2 in. above the horizontal
cut of the notch. See Figures 14 - 15.
n Never cut through to the notch. Always leave a band of
wood between the notch and backcut (approximately 2 in.
or 1/10 the diameter of the tree). This is called "hinge" or
“hingewood.” It controls the fall of the tree and prevents
slipping or twisting or shoot-back of the tree off the stump.
See Figures 14 - 15.
n On large diameter trees, stop the back cut before it is
deep enough for the tree to either fall or settle back on
the stump. Then insert soft wooden or plastic wedges
into the cut so they do not touch the chain. The wedges
can be driven in, little by little, to help jack the tree over.
See Figure 16.
NOTE: When bucking or felling with a wedge, it may
be necessary to remove the SAFE-T-TIP ® anti-kickback
device to allow the bar to be drawn through the cut.
After the cut is complete, the tip should be reinstalled
immediately.
n As tree starts to fall, stop the chain saw by releasing the
switch trigger and put it down immediately. Retreat along
the cleared path, but watch the action in case something
falls your way. Be alert for overhead limbs or branches
that may fall and watch your footing.
WARNING:
Never cut through to the notch when making a backcut.
The hinge controls the fall of the tree, this is the section
of wood between the notch and backcut.
NOTCH
BACK CUT
Fig. 16
Fig. 15
KICKBACK
Fig. 17
HINGE
WEDGE
OPERATION
BUCKING
See Figures 17 - 20.
Bucking is the term used for cutting a fallen tree to the de-
sired log length.
n
Always make sure your footing is secure and your weight
is distributed evenly on both feet.
n Cut only one log at a time.
n Support small logs on a saw horse or another log while
bucking.
n Keep a clear cutting area. Make sure that no objects can
contact the guide bar nose and chain during cutting, this
can cause kickback. To avoid the danger, keep the SAFE-
T-TIP
® anti-kickback device attached while cutting. Refer
to “Kickback” earlier in this manual.
n When bucking on a slope, always stand on the uphill side
of the log. To maintain complete control of the chain saw
when cutting through the log, release the cutting pressure
near the end of the cut without relaxing your grip on the
chain saw handles. Do not let the chain contact the ground.
After completing the cut, wait for the saw chain to stop
before you move the chain saw. Always stop the motor
before moving from tree to tree.
n Sometimes it is impossible to avoid pinching (with just
standard cutting techniques) or difficult to predict which
way a log will settle when cut. To avoid pinching while
cutting, rotate or move the log so that the pinch is elimi-
nated.
Fig. 18