Russound PR-4Zi - Manual (Page 14)

14
DSC/DAN KEYPADS
Once the PCK(IR) keypads have been wired, con-
nect the DSC keypad’s 16-pin header to the 16-
pin receptacle on the side of the main keypad
(see Figure 1a and 1b). Be sure to keep the cor-
rect pin alignment. If you are using a DAN key-
pad with the system, connect it to the input
receptacle on the side of the DSC keypad. OPERATING THE DSC/DAN KEYPADS
Select the source that you wish to control
on the main keypad (this will also select the
source for listening).
Press the command key(s) on the DSC or
DAN which have been programmed with the
commands that you wish to execute.
The Program indicator will flash as the
command is outputted. If the Program
indicator does not flash when the
command key is pressed, the
command was not stored properly.
TREBLE VOLUME BASS
PR-4Z SYSTEM CONTROLLER
SELECT
CD TAPE TUNER
VID2 DVD VID1
ZONE ON/OFF PRESET LOUD
SYSTEM OFF SYSTEM ON
PRG CLR RST
IR IN PRG ST
O ERR
DIRECT ACCESS
NUMERIC SOURCE KEYPAD
8 9 7
5 6 4
2 3 1
0 ENTER
PRG CLR RST
IR IN PRG ST
O ERR
DIRECT SOURCE CONTROL
SEEK
MODE
SELECT
SCAN
PCK-IR OR PCK DSC DAN
Figure 13 – DSC and DAN docking
1
2
3
Peripheral Devices
PR-4Zi manual 6/18/02 12:58 PM Page 14