Russound PR-4Zi - Manual (Page 17)

Peripheral Devices
17
IR EMITTERS
The PR-4Zi has seven IR outputs:
Source 1–6 and Common. Source
1–6 outputs are source-specific and
provide IR signals only to the
selected source; the Common out-
put provides IR signals to all
sources.
Source-specific IR outputs (Figure
17) are useful when a system has
two or more of the same model
source component, allowing you to
target the IR commands to each
individual component.
To connect multiple emitters to the
Common IR output, use the
Russound 857 connecting block
and a 1/8-inch (3.5mm), 2-conduc-
tor (mono) phone plug as shown in
Figure 18. Connect common (COM)
IR output to “IR INPUT” on the 857
connecting block.
Figure 18 – Common infrared output
TIP
SLEEVE
1/8" (MONO)
PHONE PLUG
STRIPE WIRE
IS SIGNAL
(WIRES TO TIP)
RUSSOUND #857
CONNECTING BLOCK
1 2 3 4 5 6
IR R
ECEIVER
I
N
IR C
OMMON
I
N
IR C ONFIRM
+
12VDC
GND STATUS SIGNAL
E MITTERS
S
TATUS
+
12VDC
P
OWER
+
12VDC
DESIGNED IN USA MADE IN KOREA
857 I NFRARED
C ONNECTING B LOCK
RUSSOUND #845.1 MICRO EMITTERS
TO IR CONTROLLED EQUIPMENT
845.1 MICRO EMITTERS TO
IR RECEIVER WINDOW
OF SOURCE EQUIPMENT
SOURCE 2
SOURCE 1
Figure 17 – Source-specific infrared outputs
PR-4Zi manual 6/18/02 12:58 PM Page 17