Roland TD-3KW - Manual (Page 5)

5
USING THE UNIT SAFELY
fig.PD-85.e_80
add
* Do NOT place your fingers inside the shell, as you may hurt
yourself or cause damage to the PDX-8. Or when changing the
head, do NOT touch any of the internal parts. Also, do not
insert your fingers into the hole of the mounting bracket.
fig.Stand.j
fig.Stand.j
Before using the pad, tighten the
head so that the tension is rather firm.
Looseness in the head tension may result in problems such as
failure of the PDX-8’s rim shots to sound or double triggering.
Striking the head when the head tension is loose may
damage the sensor.
1. Use a tuning key to tighten the tuning bolts.
Strike the head to check the feel and response.
fig.Adjust.e
Tighten each tuning bolt one by one, observing the
numerical order shown in the diagram. Do not firmly
tighten a single tuning bolt by itself. Doing so will make
it impossible to tension the head evenly, and will cause
malfunctions.
fig.Bolt
2. Fine-tune the adjustment while continuing to
check the pad feel and response.
• On the PDX-8, adjusting the head tension affects only the
head response, and does not change the pitch of the
sound as it would on an acoustic drum.
• Head tension may slacken with the passage of time.
Readjust the tension as needed.
PDX-8
(Snare)
Rim Rubber
Hoop
Tuning Bolt
Stand Fixing Screw
Head
Head Sensor
Rim Sensor
Holder
Shell
Output Jack
Head Sensor
Head Sensor
Rim Sensor
Adjusting the Head Tension
Loosen Tighten
1
3
4
2
5
6
TD-3KW_e.fm 5 ページ ２００７年６月１９日 火曜日 午後３時１２分