Operation, Warning, Cutting warped material – Ryobi TS1300 User Manual
Page 20: Clamping wide workpieces, Page 20, Right, Wrong wide board c-clamp
Page 20
45
15
0
30
1 5
3 0 ˚
0
0
CUTTING WARPED MATERIAL
See Figures 24 and 25.
When cutting warped material, always make sure it is
positioned on the miter table with the convex side against the
fence as shown in figure 24.
If the warped material is positioned the wrong way as shown
in figure 25, it will pinch the blade near the completion of the
cut.
WARNING:
To avoid a kickback and to avoid serious personal injury,
never position the concave edge of bowed or warped
material against the fence.
CLAMPING WIDE WORKPIECES
See Figure 26.
When cutting wide workpieces that are too wide to be
clamped with the work clamp provided, a C-clamp must be
used. For example, when cutting 2 in. x 6 in. boards, they
should be clamped with a C-clamp as shown in figure 26.
OPERATION
Fig. 24
Fig. 25
Fig. 26
0
°
15
°
30
°
45
°
15
°
30
°
45
°
RIGHT
0
°
15
°
30
°
45
°
15
°
30
°
45
°
WRONG
WIDE
BOARD
C-CLAMP