Omron VIBRATING MESH NEBULIZER NE-U22V - Manual (Page 7)

How to Fill the Medication Bottle
13
Correct Use of the Unit
How to Fill the Medication Bottle
How to Fill the Medication Bottle
12
How to Fill the Medication Bottle
Correct Use of the Unit
Have you removed Mask Adapter and the supplied Mouthpiece?
(For how to assemble the Main Unit, refer to Page 8)
1
Remove Medication Bottle
from the Main Unit.
5
Attach the Medication Bottle to the Main Unit.
– If the Medication Bottle is not installed
correctly, the power will not turn on.
– If the Electrodes on the Main Unit are
severely stained, the unit will not nebulize
normally. In that case, wipe off the stain.
(Refer to Page 17)
3
Fill Medication Bottle.
Be careful to prevent the Mesh Cap from closing
as shown in the Figure.
– The maximum capacity of Medication Bottle is 7 ml.
4
Close the mesh cap.
– Be sure to check that the Mesh Cap
is engaged. If it is not engaged,
medication will leak.
Click
Press gray tabs on
both side of Medication
Bottle at the same
time lift upwards.
Click
Align both
electrodes with
each other.
Check that the
Mesh Cap is closed.
You have
finished assembly. You have
finished assembly.
Do not open the
bottle cap.
Lift up the mesh
cap while pressing
your thumb hard
on the brim.
2
Open the Mesh Cap.
Hold the medication bottle as if covering
it with your hand.
• How to install the Child’s Inhalation Mask
7
Attach the Child’s Inhalation Mask or the Mouthpiece.
• How to install the Mouthpiece
6
Attach the Mouthpiece, Mask Adapter.
You have
finished assembly.