Oregon Scientific Radio controlled projector alarm clock EW98 - Manual (Page 9)

7
EN
Note
1. The unit will automatically search for the time
signal at 2:00 (3:00 or 4:00 is also available if
the signal is not received at 2:00), 8:00, 14:00
and 20:00 each day.
2. Always place the unit away from interfering
sources such as TV set, computer, etc.
3. Avoid placing the unit on or next to metal
plates.
4. Closed area such as airport, basement, tower
block or factory is not recommended.
5. Do not start reception in moving articles such
as vehicles or trains.
TIME AND CALENDAR MANUAL SETTING
If you are out of reach of the Radio Controlled
sensor or if the reception is not reachable, the time
and calendar can be set manually. As soon as the
signal of sensor is received again, the clock will
automatically synchronize with the exact time and
calendar.
1. In normal time mode, press “SET CLOCK”
key once to enter the time setting mode.
2. Press “+/CHANNEL” or “-/MIN.MAX.” key to
change the settings.
3. Press “SET CLOCK” to confirm. The setting
order is: 12/24-hr format, time, +/-23 hours
time difference, year, day/month format, date.
4. Press “SET CLOCK” key to save and exit the
setting mode.
Note
1. D u r i n g t h e s e t t i n g p e r i o d , p r e s s a n d
hold the “+/CHANNEL” or “-/MIN.MAX.” key
to speed up the change of settings.
2. Through “+/-23 hours time difference” setting,
the precise time of another area will be shown.
ALARM TIME SETTING
1. In normal time mode, press “SET ALARM”
key once to enter the alarm time setting mode.
2. Press “+/CHANNEL” or “-/MIN.MAX.” key
to set hour/minute.
Time setting 12/24 Hr setting Time difference setting
Year setting MD/DM setting Month-Date setting