One for All Kameleon URC-6690 - Manual (Page 15)

O WNER ’ S M ANUAL
Programming Favorite Channel Scan 13
3. To stop scanning channels at any time,
press any key once.
PROGRAMMING FAVORITE
CHANNEL SCAN
In the TV, VCR/PVR, DVD and CBL/SAT
modes, you can store a list of up to 10
favorite channels, in any order, that will be
immediately scanned when FAV is pressed
(see Using Channel Scan).
NOTE: Only channels of one mode can be
stored for Favorite Channel Scan.
1. On the remote control, press TV,
VCR/PVR, DVD or CBL/SAT once.
2. Press and hold SET until the two Inner
IR segments flash twice. The current
mode key will blink on and off during
programming.
3. Enter 9 9 6. The Inner IR Animation
will blink twice.
4. Use the keypad to enter a favorite
channel number (e.g., 0 3 1). Then
press SET once.
NOTE: If the original remote control required
pressing an Enter key to change the channel,
also press the Enter key after the channel
number (e.g., 0 3 1 Enter).
5. If desired, repeat step 4 (in this
section) for each favorite channel to be
stored, up to a total of 10 channels.
NOTE: If you try entering more than 10
channels, the remote control will
automatically exit programming.
6. To exit programming, press and hold
SET for 3 seconds. The Inner IR
Animation will blink twice.
USING LEARNING
The OFA Kameleon™ 6-Device Hybrid
Remote (URC-6690) includes a Learning
feature so you can add functions that are
unique to your home entertainment devices
(e.g., DVD EJECT). However, there are some
considerations.
L EARNING P RECAUTIONS
• Your original remote controls must be
in working order for learning to work
properly.
• Learned keys are mode specific, so
each one can store a unique function
for each mode.
• Learned keys can be used in macros
(see Using Macros on page 11).
• Do not use the following keys for
learning: Device Keys, SETUP, FAV, or
Record (•) Key.
• Learning capacity is approximately 50
to 70 keys, depending on the code
being learned.
• If both learned and keymoved
functions are assigned to the same key,
the last programmed function is
stored.
• A learned function cannot be used as a
source for Keymover (see Using
Keymover on page 15).
• Certain device codes are not learnable
including multi-frequency types, some
high frequency ones, and other
unusual formats.
• For optimum learning, avoid high
levels of ambient light such as natural
sunlight or energy-efficient fluorescent
lights.
OFA Kam 6 Hybrid Owners Manual.fm Page 13 Wednesday, March 30, 2005 3:09 PM