Sylvania 6727DG - Manual (Page 26)

26
EN EN EN
TIME SEARCH
This function allows you to quickly advance the tape
to your desired position simply by entering the exact
amount of playback time you want to skip.
In the example below: To watch a program before/
after 2 hours 50 minutes from the present position,
in either direction.
1
Press [SET-UP].
Use [
K K / L L ] to point to "TIME SEARCH", then
press [ENTER].
2
Use [ K K / L L ] until your desired
time appears.
To cancel the Time Search at
this point, press [SET-UP].
3 Use [s s / B B ] to rewind or fast forward to the
specified point.
The time counts down during the search. When
the counter reaches "0:00:00", the tape will start
playback automatically.
TO CANCEL DURING TIME SEARCH
Press [STOP/EJECT C A] on the unit or [STOP C C ].
NOTE:
• Time Search can be set up to a maximum of 9 hours 50
minutes (9:50) by 10 minutes at a time.
INDEX SEARCH
This function allows you to index the starting point
to make it easy to reach the point in either fast for-
ward or rewind mode.
• Every time you start recording, an index is marked
automatically. The index mark also works as the
starting point of Timer recording and OTR.
• The index mark will not be recorded if [PAUSE F F ]
is used during recording.
• The time gap between making the index marks on
the tape should be greater than 1 minute for SP
recording, 2 minutes for LP recording and 3 min-
utes for SLP recording.
• In some cases, the index mark at the beginning of
video tape cannot be detected.
Example: You are watching program number 4 and
want to fast forward to program number 7. Skip
three programs.
Pro.1 Pro.2 Pro.3 Pro.4 Pro.5 Pro.6 Pro.7
4 3 2 1 1 2 3
End of
the tape
Beginning of
the tape
CURRENT PLAYBACK PROGRAM
INDEX MARK
1
Press [SET-UP].
Use [
K K / L L ] to point to "INDEX SEARCH", then
press [ENTER].
2
Use [ K K / L L ] until the number
of programs that you want to
skip appears.
3 Use [s s / B B ]. The unit begins rewinding or fast
forwarding to the beginning of desired program.
4 When the search is completed, the unit will start
playback automatically.
• The numbers of Index Search can be set up to
20.
• This function is not available during recording.
TO CANCEL DURING INDEX SEARCH
Press [STOP/EJECT C A] on the unit or [STOP C C ].
PICTURE SEARCH
This function is useful in finding or skipping over a
particular scene on a tape. In this mode, the sound
will be muted.
1 During playback, press [REV E E ] or [FWD D D ]
to view at a high speed (in reverse/forward).
2 Press [REV E E ] or [FWD D D ] again to view at
super high speed (in LP/SLP modes only).
3
Press [PLAY B B ] to return to normal playback.
NOTE:
• Tapes recorded in the SP or LP mode will normally display
a noise bar on the TV screen and the picture may revert to
black and white.
VCR VCR
VCR
TIME SEARCH
2 : 50
INDEX SEARCH
0 3
VCR SECTION
SEARCH FUNCTION