Onkyo Network A/V Receiver HT-R690 - Manual (Page 18)

18
En
With (Remote Interactive), you can use the following
special functions:
■
System On/Auto Power On
When you start playback on a component connected via
while the AV receiver is on Standby, the AV
receiver will automatically turn on and select that
component as the input source.
■
Direct Change
When playback is started on a component connected via
, the AV receiver automatically selects that
component as the input source.
■
Remote Control
You can use the AV receiver’s remote controller to
control your other
-capable Onkyo components,
pointing the remote controller at the AV receiver’s
remote control sensor instead of the component. You
must enter the appropriate remote control code first
(
➔
page 62).
Note
• Use only cables for connections. cables are supplied
with Onkyo components.
• Some components have two jacks. You can connect either
one to the AV receiver. The other jack is for connecting
additional -capable components.
• Connect only Onkyo components to jacks. Connecting other
manufacturer’s components may cause a malfunction.
• Some components may not support all functions. Refer to
the manuals supplied with your Onkyo components.
• While Zone 2 is on, the System On/Auto Power On and Direct
Change functions do not work.
See “Recording” for details on recording (
➔
page 38).
Note
• The AV receiver must be turned on for recording. Recording is
not possible while it’s in standby mode.
• If you want to record directly from your TV or playback VCR to
the recording VCR without going through the AV receiver,
connect the TV/VCR’s audio and video outputs directly to the
recording VCR’s audio and video inputs. See the manuals
supplied with your TV and VCR for details.
• Video signals connected to composite video inputs can be
recorded only via composite video outputs. For example, if your
TV/VCR is connected to a composite video input, the recording
VCR must be connected to a composite video output.
• The surround sound and DSP listening modes cannot be
recorded.
• Copy-protected Blu-ray Discs and DVDs cannot be recorded.
• Sources connected to a digital input cannot be recorded. Only
analog inputs can be recorded.
• DTS signals will be recorded as noise, so don’t attempt analog
recording of DTS CDs or LDs.
Connecting Onkyo Components
1 Make sure that each Onkyo component is
connected with an analog audio cable (connection
in the hookup examples) (
➔
page 16).
2 Make the connection (see the illustration).
3 If you’re using an RI Dock, or cassette tape deck,
change the Input Display (
➔
page 37).
L R
ANALOG
AUDIO OUT
L R
ANALOG
AUDIO OUT
e.g., CD player
RI Dock
Connecting a Recording Component
AUDIO
IN
L R
VIDEO
IN
VCR, DVD recorder,
cassette tape deck,
CDR, MD recorder, etc.