Onkyo Network A/V Receiver HT-R690 - Manual (Page 27)

27
En
■
Tuning into stations by frequency
You can tune into AM and FM stations directly by
entering the appropriate frequency.
Presetting AM/FM Stations
You can store a combination of up to 40 of your favorite
AM/FM radio stations as presets.
Note
• You can name your radio presets for easy identification
(
➔ page 47). Its name is displayed instead of the band and
frequency.
■
Selecting Presets
■
Deleting Presets
1 On the remote controller, press TUNER repeatedly
to select “AM” or “FM”, followed by D.TUN.
(Actual display depends on the country.)
2 Within 8 seconds, use the number buttons to enter
the frequency of the radio station.
For example, to tune to 87.5 (FM), press 8, 7, 5.
If you have entered the wrong number, you can retry
after 8 seconds.
1 Tune into the AM/FM station that you want to
store as a preset.
See the previous section.
2 Press MEMORY.
The preset number flashes.
(Actual display depends on the country.)
3 While the preset number is flashing (about 8
seconds), use
PRESET / to select a preset from
1 through 40.
4 Press MEMORY again to store the station or
channel.
The station or channel is stored and the preset number
stops flashing.
Repeat this procedure for all of your favorite AM/FM
radio stations.
1 To select a preset, use PRESET / on the AV
receiver, or the remote controller’s CH +/–.
Tip
• You can also use the remote controller’s number buttons to
select a preset directly.
1 Select the preset that you want to delete.
See the previous section.
2 While holding down MEMORY, press TUNING
MODE.
The preset is deleted and its number disappears from
the display.