Olympus CAMEDIA X-350 PT-021 - Manual (Page 21)

Installation and Removal of the LCD Hood
Installation
Strongly push the mounting projections of the LCD hood as shown in
the figure into the guides above and below the LCD monitor window.
Removal
Remove the mounting projections of the
LCD hood from the guides above and
below the LCD monitor window by
widening the LCD hood.
Installation Removal
Perform the final checks.
Visual Inspection
After sealing the Case, check the sealing part of front and rear lid
visually to confirm that the O-ring is not twisted or out of the groove
and that no foreign matter has been caught.
: • Hairs, fibers, and other narrow items are not very
apparent, but they may cause entry of water, so that
special attention is required.
CAUTION
Fit the lens cap onto the lens
ring as shown in the figure. Be
sure to remove the lens cap
before shooting.
Mounting and Removing the Lens Cap