Oki B930d - Manual (Page 125)

B930n User’s Guide> 129
U SING E THER T ALK
This section provides information on the possible causes, verifying
methods and recommended actions pertaining to errors which may
occur when the printer is used with EtherTalk. The printer is not
Printing
CAUSE TREATMENT
The name (or the
default name) of
the printer has
been changed.
Cause The Apple Talk function of the printer
name if it detects that a printer of the
same name exists on the network.
Verification Check Chooser to confirm that the
printer name has been changed.
Action Change the name of the printer or
change the name of the other printer to
avoid duplicate printer names on the
network.
Unable to obtain
desired print
results.
Cause 1 The print language of the printer and
that of the print drawer are different.
Verification 1 Check the print language set up for the
printer and that for the printer driver for
Macintosh.
Action 1 Ensure that PostScript and Adobe PS are
set up as the print language for the
printer and printer driver respectively. If
the print language of the printer is the
dump mode, the print data sent from
Macintosh will be output in hexadecimal
notations.
Cause 2 The printer driver which came with the
printer is not set up on the Macintosh. A
printer driver of another maker has
been used instead.
Verification 2 Check the installation procedure for the
printer driver which came with the
printer again and confirm that the
printer driver is installed on the
Macintosh. Check that the printer driver
which came with the printer appears in
the Chooser.
Action 2 If garbled characters are still printed
after the printer driver for the printer
has been selected, contact service. If a
printer driver of another maker is used,
the printer may not print properly.