Oki 12i - Manual (Page 51)

OKIPAGE 12i User’s Guide 41
➦
4
Problem Solving
Maintenance Menu Mode
MESSAGE: USER MNT
Explanation: Maintenance Menu has been accessed.
Action:
Press MENU button to see categories.
MESSAGE: MENU RESET
Explanation: Menu reset option has been accessed.
Action:
Press ENTER to reset Menus 1 & 2 to factory settings,
or press MENU to see next category.
MESSAGE: HEX DUMP
Explanation: Hex Dump option has been accessed.
Action:
Press ENTER to start hex dump of received data, or
MENU for next category. Power OFF/ ON to exit hex
dump mode.
MESSAGE: DRUM CNT RESET
Explanation: Drum Counter Reset option has been accessed.
Action:
Press ENTER to reset drum counter, or press MENU for
next category.
MESSAGE: OP MENU
Explanation: Control panel Enable/ Disable category accessed.
Change to Disable to deactivate control panel; features
can be controlled only through software. To reset, enter
Maintenance Menu.
Action: Press > to toggle enable/disable then press
ENTER.
Cleaning/Maintenance
MESSAGE: xxxxx
TONER LOW
Explanation: Toner is running out. Another message can display on
the first line.
Action: Replace toner cartridge when print quality deteriorates.
MESSAGE: TONER SNS
Explanation: A fault occurred in the toner sensor; image drum car
tridge is not properly installed.
Action: Install/reinstall image drum cartridge. If not cleared,
contact Service.
MESSAGE: xxxxx
CHG DRUM
Explanation: Drum near end of life. Another message can display on
the first line.
Action: Normal operations continue. Replace Image Drum
Cartridge when print quality deteriorates.
MESSAGE: xxxxx
FUSER
Explanation: Fuser near end of life. Another message can display on
the first line.
Action: Normal operations continue. When print quality deterio
rates, contact service to replace fuser.
MESSAGE: COVER
Explanation: Cover is open.
Action:
Close cover.