Directions, Direcciones – Oster 4781 User Manual

Page 9

Advertising
background image

5

directions

• Place unit on a clean, dry surface with at least

six inches of clearance on all sides.

• Peel off the static label from the door.

• To open the door, slide it counterclockwise.

• Cooking basket should be removed from the unit

before loading with food.

• Vegetables or cut-up pieces of meat must be

placed inside the basket around the spit.

• Chicken, roasts or other large cuts of meat

should be skewered through the spit as follows:

– Lift tines to the top of the spit.

– By holding the tines with one hand,

skewer the spit through the meat.

– Screw the spit into the cooking basket until

spit stops turning. DO NOT SCREW
THE SPIT TOO TIGHTLY.

– Once the spit is secured, lower the tines

and press them into the meat.

CAUTION: THE SPIT AND TINES
HAVE SHARP ENDS.

N

OTE

: Chicken or other poultry should be

placed with the neck-end up, legs down.

• Position drip pan inside the Rotisserie.

• Lower basket onto center of the drip pan.

• Plug cord into appropriate outlet.

• Set the timer for correct cooking time.

• Cooking times vary by the size and type of food

and recipes. The maximum capacity for the
rotisserie is 8 pounds. (See recipes section
for cooking times)
.

• The unit needs to cool for at least one half hour

before using it again. Allow your Rotisserie
to cool before cleaning and storing.

Step-By-Step Directions

5

direcciones

•

Coloque la unidad en una superficie seca y limpia al menos

separada por 16 cm de cualquier cosa a su alrededor .

•

Despegue la etiqueta estática de la puerta.

•

Para abrir la puerta, deslice en el sentido contrario

delas

manecillas del reloj.

•

La canasta de cocción deberá ser removida de la unidad

antesde colocarle los

alimentos.

•

Los vegetales o pedazos cortados de carne deben ser colocados

adentro de la canasta alrededor de la varilla.

•

El pollo, asados u otros cortes de carne grandes deberán ser

atravesados por la varilla de la manera siguiente:

– Levante las puntas para ensartar hasta arriba de

lavarilla.

– Sujetando las puntas para ensartar con una mano,

atraviesela carne con la varilla.

– Atornille la varilla en la canasta de cocción hasta que

éstedeje de dar vueltas. NO

ATORNILLE LA V

ARILLA

MUY FUERTE.

– Una vez que la varilla ha sido asegurada, baje las puntas

para ensartar y presiónelas contra la carne.

CUIDADO: LA V ARILLA Y LAS PUNT

AS TIENEN

PICOS MUY FILOSOS.

N

OTA

: El pollo y otras aves se deben de colocar

cone

lcuello hacia arriba y las patas hacia abajo.

•

Coloque el plato recolector adentro del Asador .

•

Baje la canasta hacia el centro del plato recolector .

•

Conecte el cordón eléctrico en la toma de corriente adecuada.

•

Ajuste el cronómetro con el tiempo necesario de cocción.

•

El tiempo de cocción varía según el tamaño y el tipo de

alimentos y la receta. Lamáxima capacidad para el Asador

esde 3.6 k.

(Vea la sección de

recetaspara los tiempos de

cocción).

•

La unidad necesita enfriarse por lo menos una media hora

antes de volverse a usar . Permita que su Asador se enfríe

antesde limpiar y almacenar

.

Direcciones Paso a Paso

Advertising