Formatting the internal memory/card, Selecting a display language, Adjusting the image processing function – Olympus ADVANCED MANUAL FE-200 User Manual
Page 25: Changing the monitor brightness, G“k/q turning on the power with the k/q” (p.25), Q turning on the power with the k/q” (p.25)
Me
nu operati
o
ns
EN
25
All existing data, including protected pictures, are erased when the internal memory or
card is formatted. Make sure that you save or transfer important data to a computer
before formatting.
• Make sure there is no card inserted in the camera when formatting the internal
memory.
• Be sure that the card is inserted in the camera when formatting the card.
• Before using non-Olympus cards or cards which have been formatted on a
computer, you must format them with this camera.
Insert the optional card into the camera. Copying data does not erase the pictures in
the internal memory.
• It takes some time back up data. Make sure that the battery has enough power
before starting the operation. Or, use the AC adapter.
You can select a language for on-screen display. Available languages vary depending
on the area where you purchased this camera.
You can add other languages to your camera with the provided OLYMPUS Master
software.
The pixel mapping feature allows the camera to check and adjust the CCD and image
processing functions. It is not necessary to operate this function frequently.
Approximately once a year is recommended. Wait at least one minute after taking or
viewing pictures to allow the pixel mapping function to perform properly. If you turn the
camera off during pixel mapping, start again.
Select [PIXEL MAPPING] and when [START] is displayed, press
i.
You can turn on the power by pressing either
K or
q.
MEMORY FORMAT (FORMAT)
...................Formatting the internal memory/card
BACKUP
.................................... Copying pictures in the internal memory to the card
W
................................................................................... Selecting a display language
PIXEL MAPPING
........................................Adjusting the image processing function
K/
q
.................................................................Turning on the power with the
K/
q
YES/ NO
s
................................................................................Changing the monitor brightness
BRIGHT/ NORMAL
BEEP
................................. Adjusting the volume of beeps when buttons are pressed
OFF (No sound) / LOW /HIGH