Onkyo CR-715 - Manual (Page 9)

9
Getting to Know the CD Receiver—Continued
The page numbers in parentheses show where you can find the main explanation for each item.
A LINE 1 IN (22)
This analog audio input is for connecting a compo-
nent with an analog output, such as a TV, or a turn-
table with a built-in phono equalizer.
B MD/TAPE IN/OUT (18, 19)
These analog audio inputs and outputs are for con-
necting a recorder with an analog input and output,
such as a MiniDisc recorder or cassette deck.
C DAB ANTENNA (CR-715DAB only) (14)
This jack is for connecting a DAB antenna.
D FM ANTENNA (14, 15)
This jack is for connecting an FM antenna.
E SUBWOOFER PRE OUT (17)
This jack is for connecting a powered subwoofer.
F DC OUT (CR-715DAB only)
This jack is for powering the Onkyo UWL-1 Wire-
less USB Audio Transport. Only connect the special
cable included with the UWL-1. Do not connect any
other cable, as it will cause a malfunction. See the
UWL-1’s instruction manual for more information.
G SPEAKERS (16)
These terminal posts are for connecting speakers.
H REMOTE CONTROL (18–22)
This (Remote Interactive) jack can be con-
nected to an jack on another Onkyo component.
The CD receiver’s remote controller can then be
used to control that component. To use
, you
must make an analog audio connection (RCA)
between the CD receiver and the other component,
even if they are connected digitally.
I OPTICAL DIGITAL IN (CR-715DAB only) (21)
This optical digital audio input can be used to con-
nect a component with an optical digital output,
such as a CD recorder, MD recorder, games con-
sole, satellite tuner, or personal computer. Use a
commercially available optical digital audio cable
to make the connection.
J DOCK/CDR IN/OUT (20, 22)
These analog audio inputs and outputs are for con-
necting a recorder with an analog input and output
such as a CD recorder, or an Onkyo RI Dock.
K Power cord (23)
Rear Panel
1 2 7 6* 4 5
8 9 * J K
3*
* CR-715DAB only
See pages 14–23 for connection information.